Corrugated Board & Single Face (2ply) Dry-End Machines

1. Slitting Section

(1) Hexagonal bar and synchronous belt combined transmission, low noise, and high power.

(2) Tungsten alloy blade, high toughness, and strength.

(3) Automatic waste board discharging device, can automatically move according to the order.

(4) Independent Schneider servo motor for each blade.

(5) Auto trim the edge, auto track the side blade, and auto suction move.

2. Tractive Section

(1) There are 2 belts (up and down) to clamp the board to transmit. To avoid board break and block.

(2) The power transmission adopts a double face synchronous belt. To ensure the up and down belts are at

the same speed. To avoid the friction to break the board. Extend the using life.

(3) Open-type design. Easy to install, repair and maintain.

3. Cutoff Section

(1) DC motor drive. Increase the precision.

(2) The up blade has a flat edge, and the down blade has a sawtooth edge. Reduce cutting resistance.

4. Transmitting Section

(1) This section has 4 parts. To ensure high speed.

(2) part 1 has a dynamic brush, to press and guide the board. To avoid block by edge curly.

(3) part 1 has a pneumatic press wheel.

(4) part 2 has a press bar, to press the board which has a big curly.

(5) part 4 has a sun wheel, to avoid curly caused by sudden acceleration while the board comes out from

the transmission part.

5. Collecting Platform

(1) To adopt a flat belt, to avoid slipping.

(2) Balance weight design, to increase the precision of motor positioning and decrease the motor loading.

(3) Automatic moving trolly.

(4) Auto counting function.

6. Additional Function

(1) Air-conditioner in the electric cabinet

(2) Constant-Tension in the board feeding part, to track the speed of a single facer.

(3) Remote control system